cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
248
Views
0
Helpful
1
Replies

Problem with the WAN link...PLease Help

I have the following problem with this interface. The link keeps good for few minutes an another time I lost the conection.Sometimes it goes up sometimes it goes down. This interface is conected to a Promina wich is conected via RF.

Do you have any idea of what can I do to fix this problem?

Thanks a lot for your help

Serial1 is up, line protocol is up

Hardware is HD64570

Description: Enlace Wan er-guamach1 - er-plcgua1

Internet address is 167.175.48.10/30

MTU 1500 bytes, BW 1024 Kbit, DLY 20000 usec, rely 255/255, load 1/255

Encapsulation HDLC, loopback not set, keepalive set (10 sec)

Last input 00:00:00, output 00:00:00, output hang never

Last clearing of "show interface" counters 16:16:33

Queueing strategy: fifo

Output queue 0/40, 0 drops; input queue 0/75, 0 drops

5 minute input rate 30000 bits/sec, 10 packets/sec

5 minute output rate 6000 bits/sec, 10 packets/sec

344583 packets input, 312103564 bytes, 0 no buffer

Received 7250 broadcasts, 0 runts, 0 giants, 0 throttles

3111 input errors, 231 CRC, 0 frame, 0 overrun, 180 ignored, 72 abort

257778 packets output, 25596295 bytes, 0 underruns

0 output errors, 0 collisions, 1430 interface resets

0 output buffer failures, 0 output buffers swapped out

20 carrier transitions

DCD=up DSR=up DTR=up RTS=up CTS=up

1 Reply 1

smif101
Level 4
Level 4

I would suggest that you start doing loops in the promina network to see where the problem is starting at. Start with a local loop in house and keep going until you are at the patch panel for the remote router.

Jason Smith

www.smif101.com

Review Cisco Networking for a $25 gift card