Other Network Architecture Subjects

I have 2 of 2600 series router connect to each other using lease line, CDP enabled. But I can't see CDP neighbor. The line protocal is still down, too. The provider confirm the line is OK. Can somebody tell me if we can know something from 'show cont...

Am I right in assume the Apr 30 04 software image WC9a is the latest for these models ? What is the licenseing deal ? IE with Cat 6006 you hvae to choose your license options to obtain a image is this the same for the switches as there seems to be on...

I have a 7200 router with a single hssi interface and another fast ethernet interface. IOS 12.2(5). I have enabled cef globably and didn't recieve any errors. I then tried to run a protcol discovery on the main hssi interface however after running a ...

Hi all,i'm going to test the PVLAN on my cat6509.I've the FWSM and IDSM2 on the same chassis.If i not use the PVLAN right now, it is possible to configure them after ( when the swith in on production with vlan) or i must do something as prerequiremen...

We have enabled multicast videoconferencing in ourlan and wan. 1) The lan is segmented with vlan configuration and L 3 Switch. 2) IP PIM is enabled in vlan 1 and vlan 16. 3) The WAN router sits in vlan 1. 4) The multicast video reaches the host...

For some reason the modem is getting, CMAC_LOG_DRIVER_INIT_IDB_RESET 0x804C0450. This has been happening either ever hour or every 2 hours, 3 to 4 minutes after the hour. This seems far too regular for something that might be a problem with signa...

I know it can do it in CatOS 8.3. Just wonder what will happen if it is converted to native 12.2SX.

Hi,i have a satellite modem connected to serial port ( PA-4T+ ) of a 7206 and everything is ok. the modem has V.35 connector. but when i connect the modem to WIC-1T or WIC-2T serial port of a 3640A router it doesn't work. i use this config under the ...

Hello,I have been asked to obtain a dump of OIDs queried by DFM. I was given a command but it just doesn't want to work.While waiting on a response from the tech handling my tac, I thought I would ask here if anyone knewright off hand, either the com...

I am trying to backup device images using RME's Software Managment (RME 3.5). I have problems backing up if a image is stored on a flash card instead of on the bootflash. It seems like RME only looks for images on the bootflash, how can I fix this?

what are the possibilites are there for a router to show high ultilization ?pls help me

OK here we go, I am configuring a Cisco 2620 with a 12.2(24) version of IOS. Is this the correct version I should be using?? when the router boots, i get an error stating that the memory required for my AIM-ATM module is UNKNOWN. I can do a diagnost...

While configuring AAA on a MSFC2 (6513), I was locked out of the device. I did a telnet to the switch (which has AAA), and attempted to seesion into the MSFC (NO LUCK!!). I attempted to access it via the console port. Once I consoled in to the swi...

Have a 7600 running Hybrid mode. when we plug a new device into the switch side we are unable to see the device untill we ping its IP from the router side. WHen you ping the device the first packet no response then the rest of them come back. Befo...