remove ip nat entry???

[relmiami]

I need to remove an entry that is forwarding all traffic to an insde ip address.

ex -

ip nat inside source static 192.168.0.10 208.B.C.D

The problem is that I need to block some ports. I know how to set up the entry but not how to remove one.

Thanks

[fabios]

Like all cisco IO commands can be negated by puttin a "no" in front of it:

no ip nat inside source static 192.168.0.10 208.B.C.D

HTH

Fabio

[relmiami]

Thanks

Robert

[mmasha]

HI

clear ip nat translation *

NIX Technical

Mohsen.

[jolmo]

If this static entry is in use you won't be able to remove it . I recommend to perform a configuration script:

clear ip nat trans * \* this clears entire NAT table*\

config t

no ip nat inside source static 192.168.0.10 208.B.C.D

exit

Performing this script assures that after clearing NAT table you can remove ip nat command before this translation install again in the table.