Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
650
Views
1
Helpful
2
Replies

RSPAN Source and Destination on Same Switch

jdetwiler
Level 1
Level 1

‎04-24-2003 07:00 PM - edited ‎03-02-2019 06:54 AM

Is it possible to have an RSPAN source and destination on the same switch? I need to watch servers on 2 6509s. The monitoring device (a NetQoS SuperAgent) is on one of those switches. Any advice on if / how this can be done?

Labels:
0 Helpful
2 Replies 2

Prashanth Krishnappa
Cisco Employee
Cisco Employee

‎04-25-2003 10:14 AM

Why don't you use regular SPAN instead?

jdetwiler
Level 1
Level 1
In response to Prashanth Krishnappa

‎04-25-2003 10:59 AM

Span would only allow me to monitor the server(s) on the same switch as the span destination port. I need to watch servers on both the switch with the monitor port as well as another switch.

0 Helpful
Customers Also Viewed These Support Documents

Review Cisco Networking for a $25 gift card