Stateful NAT question

[steve.wadge]

I'm implementing stateful NAT (SNAT) & have a query regarding how you create with multiple standby SNAT groups on an interface.

Going through the options it appears that once the group names have been assigned these then have to be grouped under the same snat id is this correct or can they be assigned under different id's.

[owillins]

When I tried this although multiple ids were taken during the configuration, on reloading the router this configuration was not parsed correctly. The mapping IDs default to the first group. Not sure if this is working fine now.

[steve.wadge]

Thanks for the info, sounds similar to what I'm seeing. Probably IOS revision then will try upgrading.