05-29-2006 10:49 PM - edited 03-03-2019 03:25 AM
hallo
is there a way to know if a cisco catalyst switch is working in store-and-forward, fragmentfree or cut-through ?
Can we change with ios the switching mode ?
regards
francesco
05-29-2006 11:11 PM
hi,,,
ya u can check it out which mode is going on...and u also can change it...i had done this things many days ago...at that time i had 1900 switch...
please rate this post if it helps
regards
Devang
05-30-2006 07:19 AM
hi Devang
can you tell me which ios commands can I use to see the actual switching mode of a catalyst 2950 switch and how I can change it if is it possible ?
Is there a document abut these tasks ?
best regards
francesco
05-30-2006 03:20 AM
I think almost everything is store and forward now ,the only ones I remember that were different were the old 1924's which could be cut thru if configured.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide