Other Network Architecture Subjects

I have Two Catalyst 2950 Switches, I connected both Switches through their Two Uplink Ports. Now I Want to run RSTP b/w these ports by doing this:Config t>int gi 0/1> spanning-tree mode rapid-pvstBut this command not works and shown as "Unrecognised ...

What are the most common snmp cpmmand you want to add to a Distribution switch

Hi! i am new to cisco and wnat to know one thing.....how can we manage switch from web interface....and which switches can be managed from web....i have 1924 and 2950 switch i have the console cable but dont know how to do it through web.....do i hav...

Hello,Does anyone have an idea on how to prevent the propagation of bpdu's (input and output) on a trunk running multiple spanning tree protocol (mst)?If possible, please give sample configuration?Thanks.

HI IF I Have 5 separeted dist connected to the core.i have summarized to the core; i have this network. 10.1.0.0 10.2.0.0 10.3.0.0 10.4.0.0 10.5.0.0 the routing protocole is EIGRP.i dont need to confuse the core that it can reach the 10.0.0.0 network...

hellowhen you have speed and duplex set manualy would this stop the negotiation with the other site ?

HIIF I Have 4 dist connected to the coreshould i summurize from one dist or on all the dist.i have this network.100.1.0.0100.2.0.0100.3.0.0100.4.0.0100.5.0.0the routing protocole is EIGRP.10XSALI

Hi all,I am trying to figure out the exact difference between the various smartport "server" roles available in CE500 (Trusted, critical, business, standard). I've search through the documents on Cisco website but could not find any document explaini...

Has anyone come across the following error:%KERNEL-1-CREATEPROCESSFAILED:Error in creating process: Unavailable free stack; stack type: 1; Name: LinkUpdPrcsAny ideas what is the cause.Thanks.

HII have advertised a Network via EIGRP to site-3 from the Core.but when advertised the network;site-7 learned all the Networks;vlan in the enterprise network from the core.i dont need the overload in the site7 also in the other site to learn every n...

My 2600 crashed and it won't reboot propperly. It isses the following error durring startup and then restarts again:*** System received a SegV exception ***signal= 0xb, code= 0x100, context= 0x829c43a8PC = 0x80464078, Vector = 0x100, SP = 0x82aca3d8...

I have the following consultation. I have a "computer A" connected to a port of switch 3750, configured with: dot1x port-control autodot1x timeout quiet-period 5The "computer A" is authorized. When I disconnect the "computer A" and I connect a "Com...