temperature status from 2960 switch using SNMP not working.

[sossie]

Hello

WS-C2960G-24TC-L   12.2(25)SEE3            C2960-LANBASE-M

I would like to get the temperature status from this 2960 switch (and several other models. Normally this OID should be:
.1.3.6.1.4.1.9.9.13.1.3.1.6

But it does not return anything.

The termperature status can be found from the command line by running:
"sh env temp"

This reports back ok, so I assume there is a temperate gauge in the switch.

This oid is part of the "CISCO-ENVMON-MIB" mib and accouding to the Cisco MIB selector it is supported on my switch and IOS - 12.2(25).

(Another thing I woudl like to monitor and should be supported is the fan status oid (.1.3.6.1.4.1.9.9.13.1.4.1.3). That doesn't return anything either.

What do I need to do to get the temperature environment status from SNMP query?

Cheers, Simon.

[nkarthikeyan]

Hi Simon,

have you enabled this command in the snmp configurations????

snmp-server enable traps envmon fan shutdown supply temperature status

Please do rate if the given information helps.

By

Karthik

[sossie]

Hi Karthik

Thanks for the response, good idea, I have enabled that but the snmp poll on that oid still fails.

I want to SNMP poll for the OID. I'm not too interested in receiving traps.

Cheers, Simon.

[ngoldwat]

Hi,

Could you post the ouput of your SNMP walk?

Reference link.

Thanks

[Pavel Pokorny]

Hi,

It looks like C2960G (24 and 48 port version) has no info about temperature - I was searching very deeply, but nothing.

C2960G-8TC-L has info :

Temperature state : .1.3.6.1.4.1.9.9.13.1.3.1.6.1004

Temperature value : .1.3.6.1.4.1.9.9.13.1.3.1.3.1004

There is also no info about fan, only about power supply.

HTH

[Pavel Pokorny]

Sorry, info about FAN : .1.3.6.1.4.1.9.9.13.1.4.1.3.1004 (for 2960G).