test pas eeprom command failed!

[liangyu]

I have a cisco 2621 router with a wic-t.I used followed command:

router#sh ver

cisco 2621 (MPC860) processor (revision 0x101) with 27648K/5120K bytes of memory

M860 processor: part number 0, mask 49

Bridging software.

X.25 software, Version 3.0.0.

2 FastEthernet/IEEE 802.3 interface(s)

1 Serial network interface(s)

32K bytes of non-volatile configuration memory.

8192K bytes of processor board System flash (Read/Write)

Router#test pas eeprom ?

<cr>

Router#test pas eeprom

Use NMC93C46 ID EEPROM [y]:

Port Adaptor [0]:

Port 0 eeprom (? for help)[?]: d //dump eeprom contents

%Read access failed

Why is this?

Thanks.

[vkapoor5]

I have tried this command on my box and I get a similar output. Looks like it is some undocumented command used by Cisco folks. What for your trying this command exactly?

[liangyu]

Hello:

So,my router show a error "slot 0 eeprom failed" when system boot,and i search some info on cisco site,i finded a command "test aim eeprom",then i try this command,but no this command,and i find a command "test pas eeprom",try it but ....:(

Why,this ?

What can i do?

Thanks.