01-29-2006 11:32 PM - edited 03-03-2019 01:37 AM
Hi,
How can I limit bandwidth to 64k for example on the interface 0/1 in a switch 3550?
Thanx
01-29-2006 11:53 PM
Hi Reza,
If you wish to limit both inbound and outbound traffic to 64k, you can do the following:
policy-map Policer
class class-default
police 64000
!
interface FastEthernet0/1
service-policy output Policer
service-policy input Policer
!
Hope that helps - pls rate posts that help.
Regards,
Paresh
01-30-2006 03:08 AM
thanks for your reply, but that did not work.
01-30-2006 04:27 AM
Hello,
you might want to try unicast stormcontrol:
interface FastEthernet0/1
storm-control unicast level 0.06
This would limit the unicast traffic to 60K (unfortunately you cannot set this value to anything more specific, since it has only three digits)...
Regards,
GP
01-30-2006 10:48 AM
Thanx
you mean we are unable to limit bandwidth on an interface in a 3550? right?
your suggession about using "storm-control", what does happen when I want to limit a Gig Ethernet to 64 K?
01-30-2006 03:41 PM
Hi Reza,
I did not include the burst parameter in that config. If you apply the following, it should work - I've justr tried it on a 3550 myself...
policy-map Policer
class class-default
police 64000 8000 exceed-action drop
!
interface FastEthernet0/1
service-policy output Policer
service-policy input Policer
!
Hope that helps - pls rate posts that help.
Regards,
Paresh
01-31-2006 03:17 AM
Thanks
01-31-2006 04:52 AM
Hi Rezam
Out of curiosity, could you advise if that worked.
Paresh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide