Other Network Architecture Subjects

Hi, how to set telnet password via network? i know that we can set telnet password via network thru CNA, when "enable password" is set. but is it possible for cisco 1700 series routers to set telnet password? bcos CNA doesn't for routers, any other o...

Some of our users recently reported problems with their new Intel based Macintosh computers when we upgraded from old Extreme Summits to Catalyst 3560 series switches. They report sluggish response from the network. We have checked the ports for ne...

Hi, i have got Cisco 1751 router, its an internet router router, below are the configuration of hte router.memory-size iomem 25ip subnet-zero!!!!interface Serial0 description connected to Internet ip address 1.1.1.1 255.255.255.252 no ip directed-bro...

Hello all, has any one used GLBP with two ISP's. I have been looking for an good example, I have not found one yet. If any one has dealt with this? I have not used GLBP before so just putting out the feelers.Basically I have a remote site connected t...

We have a 3550-12G switch which sits between our school network and our employee network. The school Novell server and the employee Novell server are both plugged into it on separate VLANs. The employee network has a Cisco 2610 router connected to ...

I have a network consisting of 2 Linksys 2024 Gig switches connected via MiniGBIC and 1 Itenel 510T switch connectd to the main Linksys via ethernet port. I want to install a new CE500 but cannot seem to get it communicating with the severs. I've t...

Can anyone please tell me what this means, i have seen this above where i put my static routes in ?

why we do marking at egress port level, if we had done marking at switching engine level too...

Hi everybody!I want to buy a Cisco router that had VIP capabilities and suports gigabit ethernet.What model do you recommend?(I prefer the cheapest model I can get)

Could any one please provide me the URL for Stack decoder' page.Thanks in advanceregards

Hi alli have 7200VXR with WCCP supportwith 4 Ethernet cardsone is connected to Intetnetone ethernet with cross cable conncted to Cache Serverone port with cross cable connected to My laptop for testing the cache server with wccpwhen i make the config...

Can anyone explain the GARP and GVRP in detail.Thanks in advance.

I have 5 3560 switches for which I've applied the same configuration, I noticed that 2 of the 5 switches accepted "service-policy input VoIP" to the switchports. I compared the IOS version and config and it's exaclty the same. Below is the config. ...