11-12-2004 12:55 PM - edited 03-02-2019 07:55 PM
How can I troubleshoot management interface SC0 in the Catalyst 6500 ? I received some error messages reported by CiscoWork managemment that there was HighDiscardRate in Sc0. When I logged in to the switch, i could not find any error logging message in the sysloy buffer. Moreover, I can't find any more commands that can help me to troubleshoot this issue . Can someone help me how to find the root cause of this issue ?
11-12-2004 01:14 PM
Can you do "sh netstat interface" and see if you see any errors? If you are, check if there is lot of traffic coming into sc0. You could sniff this interface if needed.
11-14-2004 07:22 AM
Thanks for your response. I have done the "show netstat interface"command in the switch and it seens like there are high traffic on the SC0 interface. I even sniff this vlan to our sniffer but I wouldn't find any abnormality in this interface. But when I use the sh netstat stat , it shows that there are no such port in udp stat and the value keeps on increasing. I may like to ask how to sniff this virtual port to the span port instead of using vlan to the span port .I have also attached the command result for your review and hope that from the attached doc you may help me to find the root cause.
11-14-2004 07:59 AM
No such ports indicate Number of UDP packets received destined for nonexistent ports.
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_7_6/cmd_ref/sh_ml_n.htm#wp1040770
You can do a "sh netstat" to see what ports the switch listens to.
You can sniff the sc0 in a 6500
6500> (enable) set span sc0 ?
6500> (enable) set span sc0
Check for a
11-14-2004 08:37 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide