Trying to connect a Cable Modem to a wireless router In CPT

[christ.9908]

Hi, I want to say that I'm completely new to this!

I've been following The Getting Started with Cisco Packet Tracer course, and I'm currently trying to create a simple network.
My problem comes when I connected my cable modem/wireless router with a copper cross over cable. The two are connected but there's 2 red arrows that indicate that connection is not correctly made.

What should I do??

[christ.9908 · Accepted solution]

I tried with a copper straight-through cable and it's working. I've been able to complete the exercise with this cable but they're specifically asking for a copper cross over cable, why it's not working with that type of cable?

[Georg Pauwen]

Hello,

it might be version dependent. The file below was created in version 8.1.

Post your zipped project (.pkt) file...