Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
325
Views
0
Helpful
1
Replies

Using netconfig to change user and privileged mode passwords

liamwalk
Level 1
Level 1

‎02-21-2002 07:28 AM - edited ‎03-01-2019 08:34 PM

There is a template in RME->Configuration Management->NetConfig that allows you to change the enable password:

set enablepass

%OLDPASSWORD%

******

******

If I try to create my own template that changes both the user and priveleged mode passwords, using the %OLDPASSWORD% variable, the job fails - complaining about the variable.

Is there any way I can set up this template using the %OLDPASSWORD% variable, or is the only way to type the password in manually (which I managed to get working OK)?

Labels:
0 Helpful
1 Reply 1

rmushtaq
Level 8
Level 8

‎02-21-2002 09:46 AM

See if http://www.cisco.com/warp/public/477/RME/netconfig.shtml helps

0 Helpful
Customers Also Viewed These Support Documents