Using snmpwalk to get the fdb data

[s.kadagathur]

I was wondering we have to use private MIB to get the MAC addresses in different VLANs configured on a Catalyst 4006 switch or the MIB-II dot1dTpfdbtable variable is sufficient. I appreciate the response.

[rmushtaq]

Makre sure that you use Community String Indexing: ftp://ftp.cisco.com/pub/mibs/supportlists/wsc4000/wsc4000-communityIndexing.html

For example, the Catalyst switch includes one instance of the standard BRIDGE-MIB for each Virtual LAN in the switch. If the read-only community string is "public" and the read-write community string is "private", one could use "public@25" to read the BRIDGE-MIB for VLAN 25 and use "private@33" to read and write the BRIDGE-MIB for VLAN 33. If just "public" or "private" is used, the BRIDGE-MIB for VLAN 1 is accessed.

[s.kadagathur]

I appreciat your help. Thanks.