VIC 2BRI-S/T TE or WIC 1B-S/T

[m.batts]

Hi,

I have a question that i think i already know but i just wanted to run it by some people.I have a 1760 with a VIC 2BRI-S/T interface installed.When i boot the router it just says "unknown card in slot 2"

From the documentation it seems that these cards only work in the NM-1v and NM-2V modules which a 1760 doesn;t have.This will be used as a dial backup for a WAN link so i assume that i need the WIC-1B-S/T instead.

Before i send it back any help would be gratefully received

Mark

[josrankin]

The VIC-2BRI-S/T-TE is not supported in the 1700 series. The VIC-2BRI-NT/TE is supported, as is the WIC-1B-S/T. Check this link:

http://www.cisco.com/warp/public/788/products/2isdn_bri_vic.html