Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In CPI, is there a way to change the IP address associated with a core switch that has multiple VLAN interfaces configured? When I discover a switch with multiple VLAN interfaces, it always comes back with the highest IP address. I need the address t...
Hi, I am trying to find documentation on this through the Cisco website but have been unsuccessful. I have a WS-C2960S-24PD-L switch with two SFP+ ports. The data sheet says for uplinks - "2 Ten Gigabit Ethernet SFP+ or 2 One Gigabit Ethernet SFP p...
I recently converted several autonomous APs to lightweight using Cisco Prime Infrastructure. When I attempted to upgrade the AIR-SAP1602E APs, they did not show up on the Autonomous AP list in CPI. They are in the inventory, but the device type is bl...
I have a 5508 WLC running 7.6.120.0 with several locally connected LWAPs (CAP2602E and CAP1602E) that have static IP addresses configured. The connection to the WLC was lost and the APs picked up DHCP addresses. After the connection to the WLC was re...
I have a production 2504 WLC that I have been asked to upgrade from 7.0.240.0 to 7.4.121.0. According to the Release Notes for Cisco Unified Wireless Network Field Upgrade Software, Release 1.8.0.0, the FUS 1.8.0.0 must be installed to used certain f...
I figured out a way to do it. I used a ping sweep to find only that VLAN and selected "None" under Preferred Management IP. The discovery came back with the desired address.
Thanks. The link to view the new devices supported was broken so I couldn't determine if support was added for the SAP1602E. I went ahead and converted them manually.
Thank you for that information. Do you know if the time it takes for the AP to revert to the original static IP address after the connection to the WLC is restored is configurable?
Yes it seems the 1.8.0.0 would be a waste of time since I already have the 7.4.1.30 recovery image and the 1.0.18 bootloader. Is there no command line output that would show me what FUS is installed?Since I am doing this remotely without a console co...
