VLAN's and IP ranges

[SDWorx_2]

Hello,

I was wondering if you could add 2 ip addresses in a different subnet to 1 VLAN (interface) on the MSFC module.

The reason I ask this is because of the fact that I would like to setup a host server with several virtual servers. The host server should be running in an other subnet to make my ACL's a little easier.

The ACL is different for both the host- and virtual servers.

Any other (better) suggestions are welcome.

Hardware is a Cisco catalyst 6509 with MSFC blade.

Regards

Koen

[thisisshanky]

You could add secondary addresses to the same vlan interface

int vlan 2

ip add 1.1.1.1 Mask

ip add 2.2.2.2 Mask sec

ip add 3.3.3.3 Mask sec

[SDWorx_2]

Ok thank you, I was not sure that the sec worked in vlans's.

I'll give it a try.

Thanks.