Does anyone know if there is anything new regarding vlan trunking on the 2800 Series routers? Is the syntax similar to what's shown below? If you notice in the sample below I have specified vlan 10 to be allowed across the switch port...is it necessary to specify vlans ids, or is there a default action where all vlans are passed through the trunked port?
Any suggestions regarding this would be great. Thanks.
--------------
... configure other Stuff(TM)
interface FastEthernet 0/2/0
description "The Greatest VLAN"
no ip address
switchport mode trunk
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 10
...configure other interfaces here
interface vlan 10
ip address 10.10.10.1 255.255.255.252
no shutdown
... configure other vlan interfaces here