07-04-2012 09:32 PM - edited 03-03-2019 06:40 AM
I recently bought a 2801 Cisco router and VWIC2MFT-G703 E1 card, after installing the E1 card on slot 1 am not able to detect the card, what configurations do I need to configure for me to enable the card?
Sent from Cisco Technical Support iPad App
07-05-2012 10:41 AM
Hi James,
check your IOS version because this interface is a second generation and requires a minimum of 12.3 14T . the 12.4 mainline should be the one to choose.
have a look here
http://www.cisco.com/en/US/prod/collateral/routers/ps5855/product_data_sheet0900aecd8028d2db.html
HTH
Alessio
07-05-2012 11:02 AM
The IOS is version 15.0(1)M4. Am able to see it with sh inventory command but can't can configure anything on it, it's not even visible on the sh running.
Sent from Cisco Technical Support iPad App
07-09-2012 03:03 AM
Is somewhere in running config below sentence:
"card type command needed for slot"
?
07-09-2012 05:20 AM
The card type command says itis an unrecognized command.
Sent from Cisco Technical Support iPad App
07-09-2012 06:11 AM
There is no such a command at all, or You mistype it? It should looks like this:
card type e1 0 (switch 0 to Your slot number)
or t1 if You use t1
also try to use
show controller e1/t1
btw I recommend You to upgrade Your IOS to some 15.1.x or 15.2.x version.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide