i have configured 3 server farms on my ACE Module with 3 VIP , i need to make all servers in one server farm can ping on to the VIP of the onther server farm , so i need your help please ASAP ?!!
Hello every one,we are going to introduce a new office.as we have already running a setup in older one.we have already an ASA 5510 and a RV042 router in old setup.Now i purchased 2 3560 48 port switches with enhence image and a 2611xm router. we hav...
Hi All,Right Now we are using Cisco switch model c4006.and we are looking to replacement for the same . Below are our requirements.1: Around 120 Ports (100 Mbps)2: Around 30 Ports (1Giga)3: Layer2/Layer3Can anyone suggest Which is the best model fo...
Hi Experts,This is Network Diagram only for reference :Actual Problem related to SQL SERVER security, I am searching solutionfor same last 2 years but i did not find out. How can i secure through Router or Switch End. Database is very important thin...
Hi All,I have been asked to look into upgrading our Network from 1Gb to 10Gb. We currently have the following architecture and was hoping you guys could have some suggestions on suitable Cisco kit for what i am trying to acheive.2 x Colo Mirrored 6 x...
hi all,i have a 1941 installed on a client site with 10.0.0.0/16 required subnet. WAN is via MPLS VPN. can someone let me know if it's a good practice to use secondary IP addresses or should i go using subinterface? what are the pros and cons of usin...
Hi guys.I am about to support a new customer which has two sites. There is a cisco router in one site and a juniper in the other site.I am used to monitor Delay, jitter and packet loss when using Cisco equipments.I am not used to juniper... is that p...
I have to replace cisco equipmenet and looking for an advisemy current network layout:my destination layout want to something like that:I have a couple questions:1) is that new network layout would be a good solution or is it better to do also 3750 r...
Hi all,I am in new to this wonderfull world of cisco, I am building my home lab I have got 2 routers 2800 series, 1 ASA 5505 and two switches.My ISP allocated me a range of 5 public ip addresses.My question is this: how can I configure my network so ...
Hi all,I'm having issues trying to dial into the network via ISDN. Setup is1. Users dial in via ISDN PRI/BRI or POTS.2. Users using PRI/BRI don't have a problem3. Users using the POTS modem way are getting disconnected after approx 5 sec...
I am facing issue with GNS3 , in my Topologies , when i try to run Nodes some time some nodes doesnt start. and and i cannot connect to console even.If i restart Topology , some times it works fine. and also it is changing from Node to Node. LIke if ...
