09-05-2005 01:22 AM - edited 03-02-2019 11:55 PM
We changed MTU size on 2950 and 3750 switch.
We can see MTU parameter in startup-config file for 2950 but we don't see anything in startup config file for 3750.
Where is stored this parameter for 3750 ?
09-05-2005 01:38 AM
Hi,
When you change the MTU size, you must reset the 3750 switch before the new configuration takes effect. Reset the switch after the changes and it should show you in there.
regards,
-amit singh
09-05-2005 01:44 AM
Hi,
we have reset the switch. Show system MTU is ok but nothing about MTU in startup-config
09-05-2005 02:21 AM
It doesnot show you that in startup-config on 3750. You can check it only using " show system mtu " command.
regards,
-amit singh
09-05-2005 02:47 AM
If i understand, if my switch has a crash and i need to change with a new one, i can get configuration from ciscoworks but i have to set manually system mtu in the new switch
regards
Gilles
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide