12-21-2004 04:11 PM - edited 03-02-2019 08:43 PM
I cannot get a Wic-1b-u-v2 to work in a 2610
it will not go past "ESTABLISH_AWAITING_TEI
I have upgraded image to 12.3(12)
card and same config, and cable will work in a 3640
so I know all of that is good. any suggestions?
12-27-2004 11:13 AM
You could try with a different software version, or you if you have access to Bug Toolkit, it might give you some information about whether it is a known problem.
12-29-2004 10:15 PM
Do you have the Wic-1b-u-v2 in NM-2W
This card is supported on 12.3(10) or later.
What feature set are you running? This may require an ip plus feature set
Let me know if this helps.
SteveO
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide