Briefly, I have 2 out 6 remote sites with bri cards that continue to show deactived on the layer 1 status. Telco says the lines are good. I have tried every switch type, reconfiguring, everything I can think of.any suggestions?
I cannot get a Wic-1b-u-v2 to work in a 2610it will not go past "ESTABLISH_AWAITING_TEII have upgraded image to 12.3(12) card and same config, and cable will work in a 3640so I know all of that is good. any suggestions?
thank you for help. let me show you the debug ISDN q921 results, see if that helps. the other router says PENDING ACTIVATION on the sh controller command.ISDN BR0/0 EVENT: isdn_sw_cstate: State = 0, Old State = 6ISDN BR0/0 EVENT: isdn_sw_cstate: Sta...