If the wieghted round robin differs in value from the 2950 access switch to the 3550 distutbution switch does it matter on the end on the of cos or priority queue set at the desination.
Example:2950 access switch:
wrr-queue bandwidth 10 20 40 0
wrr-queue cos-map 1 0 1
wrr-queue cos-map 2 2 3
wrr-queue cos-map 3 4 5
wrr-queue cos-map 4 6 7
mls qos map cos-dscp 0 8 16 26 34 46 48 56
Example:3550 disturbution Sw:
interface FastEthernet0/1
description Trunk
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1-4,10
switchport mode trunk
duplex full
mls qos trust cos
wrr-queue bandwidth 10 20 40 40
wrr-queue cos-map 1 0 1
wrr-queue cos-map 2 2 3
wrr-queue cos-map 3 4
wrr-queue cos-map 4 5 6 7
priority-queue out
Thank You
Mark