x.25 translation debugs

[svenb]

Is there any debug that I can use to see if data is being transferred between the x.25 segment and IP segment once the session has been established? I have a situation where the router seems to be OK with the translation but no data is reaching the end devices.

Thank you

[ciscomoderator]

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.