10-07-2012 06:50 PM - edited 03-03-2019 06:47 AM
Hey guys looking for a little advice here. I have 2 cat3524xl's and a 3550. I recently did something to the IOS that makes the switch not display any output to the console port. Not sure what I did but even doing the reset as instructed in the Cisco docs by holding the mode button foe 2 seconds after boot. I get the flashing green light but still no output. All POST tests pass according to lights so I tried different cables and all baud rates with no change. I hoocked switches back up in lab and can see them in CDP neibors but do not know how to access them from there as they have no IP assigned to them. Remember this is two of them with exact same issue. any advice would be appriciated.
Solved! Go to Solution.
10-08-2012 12:22 AM
HI Ben,
Lets try once again from beginigng:
Start Hyperterminal :
If you yre using XP OS then you will find here : Start>All Programs>Accessories>Communications>HyperTerminal
then Connect to Right port(Com1 or....)
and use this Com port settinmgs:
9600 baud
8 data bits
1 stop bit
No parity
None (flow control)
and then switch on the power of CAT 3550.
Let me know the update:
Regards
Please rate if it helps.
10-08-2012 12:22 AM
HI Ben,
Lets try once again from beginigng:
Start Hyperterminal :
If you yre using XP OS then you will find here : Start>All Programs>Accessories>Communications>HyperTerminal
then Connect to Right port(Com1 or....)
and use this Com port settinmgs:
9600 baud
8 data bits
1 stop bit
No parity
None (flow control)
and then switch on the power of CAT 3550.
Let me know the update:
Regards
Please rate if it helps.
10-08-2012 06:33 AM
OK this morning I took a fresh look at everything. I found that for some unknowen reason using my serial to USB converter was preventing output. It works with all other devices but by just using serial connection to old computer it works fine...dont understand but at least it is working. Thanks for the reply.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide