C877 Management Access

dmcquestion · ‎09-15-2005

I am new to the Cisco 877 router. When I connect a computer to one of the four FE ports I am unable to access the router. I am given an IP address by the DHCP scope but I am unable to telnet, HTTP or HTTPS into the router.

Suggestions?

Thanks,

Danny Mc?

thisisshanky · ‎09-15-2005

Danny,

Are you able to ping the router ? Also when you telnet what message do you get on the window?

Sankar Nair
UC Solutions Architect
Pacific Northwest | CDW
CCIE Collaboration #17135 Emeritus

dmcquestion · ‎09-16-2005

Nope. Just the standard conneciton failed.

I reset the router back to the factory setting and was going to try the SDM. Same problem. Even with a factory reset, I get a DHCP address (10.10.10.2) but I am unable to ping, HTTP or telnet into the router. The SDM is also unable to connect to the router.