09-27-2012 06:23 AM - edited 03-03-2019 06:46 AM
Transitioning from 3825 to 3945 (OS is 15.0(1r)M13 c3900-universalk9-mz.SPA.151-4.m4). Turning on FDL on the 3825 was easy but the same command on the 3945 doesn't work. Any ideas?
Solved! Go to Solution.
09-27-2012 07:29 AM
And what command that is ?
09-27-2012 10:50 AM
You possibly have a WVIC interface on the 3945, on these there is no support for service-module commands.
You can still use FDL via loopback commands, described in documentation.
09-27-2012 07:29 AM
And what command that is ?
09-27-2012 08:52 AM
The command on the 3825 was: service-module t1 fdl both
Doesn't seem to work on the 3945 OS. Any ideas on how to turn on the FDL for the T1 interface?
Thanks in advance for any direction you can give on this.
09-27-2012 10:50 AM
You possibly have a WVIC interface on the 3945, on these there is no support for service-module commands.
You can still use FDL via loopback commands, described in documentation.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide