L2 Etherchannel between 6513 and Nortel 450 24T L2 Switch

[kradams]

I need to create an L2 ethrchannel between my 6513's and a stack on Nortel 450 24T Layer 2 switches as part of my migration to an ALL Cisco solution.

I've tried but cannot get the port-channel to come active, I would hope someone has done this before and can provide me with the proper config on the Cisco as well as the Nortel side.

Thanks,

Kev

[Prashanth Krishnappa]

Does the Nortel switch Support LACP? If you are running hybrid software, the following page should help with the 6500's config for LACP

http://www.cisco.com/warp/public/473/126.html