cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Join Customer Connection to register!
203
Views
0
Helpful
2
Replies
javierdiaz
Beginner

Lan Segmentation

Hi..

I have installed 1 central 3550 and 2 more connected by fiber over giga ports.Al three switches are in the same Lan 192.168.1.0.I need to configure in one of this another network eg.192.168.2.0.The applications server has the ip 192.168.1.1, and i need that the new network can conncet to this device.

any ideas to do this..??

The switches has a Enhanced Image installed.

JD

2 REPLIES 2
extraco
Beginner

On the switch that you want in a different network on one of the ports do a NO SWITCHPORT and then give it an IP address just make sure you also use the IP Helper-address command.

I was configure two vlans 1 and 2, interface vlan 1 for network 192.168.1.x and interface vlan 2 for 192.168.2.x. on central 3550.The gateway of the hosts are the address configured in this interface vlan.But my problem is that from the vlan 2 i hadn´t access to host 192.168.1.1 in vlan 1 that is the application server.I configured a ip routing in the switch but i'm still no access.This must work??

JD

Content for Community-Ad