Hi everybody.I have a question on 802.1x.h1-----------hub---------f1/1-SW-------Radius server. | h2h1 is a legitimate user while h2 is not. h1 powers up while h2 is off. h1 uses 802.1x and gets authenticated...
I am planning to configure EEM to notify the expiry of CA certificate as per http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6555/ps10777/ppt_EASy_CCEN_c78-577844.pdf.I haven't been able to find tm_ccen.tar package. Anyone got experience...
I was very excited to read about the two factor authentication that Cisco and Verisign offer through the VIP and SA500 series routers. I purchased an SA540 a month and a half ago. I have been on the phone with support of both Cisco and Verisign eve...
Hi, all:I'm trying to configure TrendMicro IOS content filtering. I have this working on a separate box, running 15.1.On this particular testbed, I have a 2900 running:System image file is "flash0:c2900-universalk9-mz.SPA.152-3.T1.bin"And the followi...
Hi,Can anyone explain this error and what is a stray Segment with the IP ident 46866. I can't seem to find this error on the Cisco web site the only bug appears to be to do with Zone firewalls. I have an 877 Router on a remote site configured with ...
Once you open a port. Does that port stay open? Reason I ask I have a device and sometimes you can remote into it and some times you cant so I'm trying to eliminate the the firewall as the cause of the problem.
Hi everybody.A dhcp server assigns ip adress based on mac address carried by client hardware field in dhcp packets.One potential attack is when a rogue host mimics different mac addresses and causes dhcp server to assign the ip addresses until no ip ...
Hi everybody.I hope everyone is doing fine. The WPA and WPA 2standards have adopted IEEE 802.1X with five EAP types as the official authentication mechanisms. What are those five methods ?Thanks and have a great week.
Hi,I'm trying to configure MAB on a Cisco 3560G to work with FreeRADIUS.I have been assured that my RADIUS configuration is fine and the server is functioning properly.This is my current switch config:Header 1!version 12.2no service padservice timest...
Hello,We are running IOS12.4(5a) on a 2821 and have "ip inspect esmtp" enabled. We noticed that every day several emails end up in the postmaster account withthe following message:"A mail message was not sent due to a protocol error. 500 Firewall Err...
HiI have Cisco MARS server and I forgot password to access.However, I try to follow this instruction http://www.securitytut.com/mars-642-545/share-your-mars-experienceI can't access to MARS.Anyone have solution to solve this problem and i wouldn't li...
Hello world;I recently applied a new activation key to an ASA5512 to add the 250 anyconnect essentials user. However, after reboot, I lost the 3DES/AES license which now reads disabled.Any suggestions on how to re-install the 3DES key?I cannot find ...
When ever I create a network object in ASDM 6.0(3) the UI also wants to send the command 'asdm location (network object IP address)' to the device.What is the purpose of 'asdm locaction ....'? Is it telling the ASA-5540 that the IP address is allowe...
