Other Security Subjects

Setup: 1605 running 12.0(5)T with IPFW w/ NAT(PAT) with one public on e0 and one private on e1. I have turned off service dhcp and made sure no databases were define and no ip helper-address enabled, but everytime I scan the public side with nmap UPD...

My router shows periodically this message. What does it mean?

I have one CiscoSecure as my primary access server and a second CiscoSecure access server set up as a backup server over the WAN .can my router point to the secondary tacacs for authenication ?or it can only point to the primary server and if the pr...

No problems! looking for products that will give me visibility into as5300 usage. It will allow us to build history.

No problems! looking for products that will give me visibility into as5300 usage. It will allow us to build history.

I have a pri at the head office and bri's at the remote offices..From the pri, I wil call the remote sites..I have a bunch of 130 remote sites..i)I can configure a dialer profile for each remote site but I wonder if there is a dynamic way of doing th...

I have a pri at the head office and bri's at the remote offices..From the pri, I wil call the remote sites..I have a bunch of 130 remote sites..i)I can configure a dialer profile for each remote site but I wonder if there is a dynamic way of doing th...

What's the standard way to set up time for your network devices when you have offices in the US, Canada, the UK,...? Is it better to set up the local time of our HQ everywhere?

How do I run ospf on gre tunnel , now the tunnel comes up and goes down stating the problem of recursive routing .I have got two routers which are connected back to back , 1751 both , the serial interfaces have not been advertised through ospf , the...

Is it possible to have NAT only change the network portion of the address but keep the originating host address e.g:Start - 10.33.5.2Nat - 10.34.5.2

After running a port scan on the 11k I've found the 11k is listening on udp ports 5002, and 1024. I'd like to know why.

Is it possible to block telnet to SMTP server from port 25 with IDS. I want to create a custom signature for this but I don't know how. If I write as hello it will block all.

below is my configuration using access-class in username command,but it seems no effect when I use show line command, username hzlife access-class 101 password 7 test324access-list 101 permit tcp any host 34.17.60.1access-list 101 permit tcp any host...

I have AS/5200 access router with ISDN & Mica modem connections. I have callback configured on all Async users via Cisco Secure +.How can I get the router to preceed all dialled numbers with 132 ?This will allow my telco to route the call at a disco...

I am trying to install CSPM 2.3.3I on my laptop with Windows 2000 SP2 and IE 6.0. When I try to install 2.3.1 and 2.3.2, it tells me I need SP1 and will not let me install. When I try to load 2.3.3I, it ask me to load IE 5.5 SP2. Can anyone tell me...