Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Previously I have been able to enable 40MHz Wide channels on the AC module for 3600 access points as AC would be seen as a separate interface.
With a 3700 Access Point the AC module is integrated and hence the AC interface does not show up separ...
Hi,I have a customer that is looking for an entry level data centre solution.I have speced up 2 UCS C240 servers (with 10GB or 8GB FC) and I was wondering whether we can attach directly to external storage from the servers for now and buy a switch in...
Thanks for your reply. I should have mentioned that I am not using RRM.
I am able to set 40MHz channel on the 3600 AC module. I can't seem to work out what to do with the 3700 as the AC module is built in and not presented as a separate interface.
Could you please provide the config of the router as well as the output of a "show ip sockets". Have you had a look at this document: http://www.cisco.com/warp/public/707/21.html ?Exert: "If you have the output of a show running-configuration command...
I believe you may be running into a variation of CSCdu82424. Can you try the following work-around that we have found? Workaround: Edit the files interceptor.c,linuxcniapi.c and IPSecDrvOS_linux.c and replace this line: #include with these lines: #i...
What OS are you running on your member server? If you're running win2k with sp2 then that's were your problem lies. There will be a few bugs created in the next few days that relate to these issues.
