Other Security Subjects

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 

Forum Posts

I am trying to load the CSPM demo on an NT 4 SP6 system.Setup advised I needed IE5 and helpfully opened up the MS IE site from where I downloaded the only version on offer - IE6.Foolishly, I assumed a version > IE5 would be acceptable. It was not. ...

niemeyjt by Level 1
  • 658 Views
  • 2 replies
  • 0 Helpful votes

In the readme for CSIDD223 it states that the NSDB can be downloaded from http://www.cisco.com/kobayashi/sw-center/internet/netranger.shtmlthis link does not exist. Does anyone have a functioning link where I can get the most recent signatures? Tha...

silverm by Level 1
  • 888 Views
  • 3 replies
  • 0 Helpful votes

Hello,one of my sensors is listening to traffic using the SPAN feature on a switch, and this is probably causing trouble on the switch. Is there any history of trouble with the spwr interface, or could it just be that the spanning is not set up corre...

rpilskog by Level 1
  • 506 Views
  • 1 replies
  • 0 Helpful votes

The radius works fine, but I'm trying to create a profile so I can restrict the vpn users to certain services, addresses on the vpn tunnel. I have tried a little with the vendor string and filter id. But now luck. The Pix sems to ignore the vendor st...

roykt by Level 1
  • 484 Views
  • 1 replies
  • 0 Helpful votes

Since Cisco promotes the use of access-list over conduits, we are going to use only access-lists in a new pix setup.But some questions came up.Who has the higher priority, access-lists or conduits ??If an access-list allows access and a conduit match...

masan by Level 1
  • 723 Views
  • 3 replies
  • 0 Helpful votes