Cisco IPS 4260 Sensor

[may272007]

Hi Team,

Need advice or steps to do factory reset on Cisco IPS 4260 Sensor. Current device is not in support, hence can't raise any TAC case in this case.

I need steps to do factory reset. its bit urgent, any help would be much appreciated.

BR,

Rohit

[Marvin Rhoads]

recover application-partition

That will delete everything except the few network settings (ip address, gateway netmask etc.)

Reference: http://www.cisco.com/en/US/docs/security/ips/5.0/configuration/guide/cli/cliimage.html#wp1060091

[may272007]

Hi Marvin,

I am not able to login to this device, hence can't run the command. Is there any other way we can do a factory reset. I do know there is some button, but not able to recollect this for this device.

Can you confirm if there is any factory reset button for this device, so that i can use that.

Br,

Rohit

[Marvin Rhoads]

There is no factory reset button on any of the Cisco IPS sensor appliances.