Factory reset through ASDM to ASS 5510

[djames]

I did a factory reset on a 5510 that we are currently testing before deploying and now I can not get back in. No console cable, no factory dhcp addressing on the management interface. NADA. Any suggestions??

[a.kiprawih]

Hi,

The inside interface of the ASA is assigned 192.168.1.1 by default. Use cross-over cable to connect it direct to your laptop, or use straight cable through switch/hub.

Use your web-brower (https) to start configuring the box again.

http://www.cisco.com/en/US/partner/products/ps6120/products_getting_started_guide_chapter09186a00805e2928.html#wp1035910

Hope this helps.

Rgds,

AK

[djames]

The ASA5510 and the SSM-10 module has now been reset to its factory default configuration. Three Cisco tech and the last one was able to help me.