cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
605
Views
0
Helpful
2
Replies
Highlighted
Beginner

ip urlfilter server command not found - Websense

Hi Ciscomates,

I'm trying to enable websense filtering in a 2921 but "ip urlfilter server" command is not available, this is my setup,

CISCO2921/K9

C2900 Software (C2900-UNIVERSALK9-M), Version 15.4(3)M3

------------------------------------------------------------------------
Technology Technology-package Technology-package
Current Type Next reboot
------------------------------------------------------------------------
ipbase ipbasek9 Permanent ipbasek9
security securityk9 Permanent securityk9
uc None None None
data None None None
NtwkEss None None None
CollabPro None None None

When I try to configure url filter I have some commands but not one for server,

yourname(config)#ip urlfilter ?
alert      Enable alerts
allow-mode               Turn on/off allow-mode
audit-trail                    Enable logging of URL information at router
cache                  Specify size of the cache and timeout value of cache
                           entries
exclusive-domain                          Specify the exclusive domain name
max-request                       Specify maximum number of pending request
max-resp-pak                          Specify the number of http responses that can be buffered
source-interface                        Specify source interface
truncate                          Truncate url
<cr>

Any ideas?

2 REPLIES 2
Highlighted
Beginner

any ideas?

Highlighted

It seems like this command is removed in 15.4(3)M

Effective with Cisco IOS Release 15.4(3)M, the ip urlfilter server vendor command is not available in Cisco IOS software.

http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/security/d1/sec-d1-cr-book/sec-cr-i3.html#wp3607384286