max number of Ethernet interface supported on 6.2(2)

[mcardell]

Good morning,

I have a pix 525 UR with Pix 6.2(2) version. I am fingind any confirmation about the maximum number of physical interface supported. I think they are 10, but I found confirmation of it in the 7.0(1).

Is it the same case for the 6.2(2)?

Any link to confirm it in the CCO?

Thanks

[hperez]

Hi Macardell

You can see the maximum number of interfaces with the command "Show ver"

This command returns as following:

...... (omited output)

.......

Maximum Physical Interfaces:3

Maximum Interfaces: 5

....

....

The Maximum Physical Interfaces is the number of phisical interfaces, and Maximum Interfaces includes virtual interfaces.

I hope this can help you.

Best Regards

Roberto

[mcardell]

Thanks,

Have you got any link that can confirm it?

If I do not have the card still I cannot really check it.

Is the output you got from a 525 UR?

[mcardell]

Thanks,

Have you got any link that can confirm it?

If I do not have the card still I cannot really check it.

Is the output you got from a 525 UR?

[hperez]

It is a command you can use in any platform and any version.

Here you have the link you requested.

http://www.cisco.com/en/US/partner/products/sw/secursw/ps2120/prod_release_note09186a00801a6d21.html

I put the output for PIX 525UR.

Regards

Roberto