PPTP connection between a PIX6.01 and W2KPRO URG PLS

[scolombo]

I've setup a VPN-PPTP connection for a remote user with Win2K PRO and a central site with a PIX .

The logon proces works fine and the user gets an ip address correctly as the following line from PIX's log states

"%PIX-6-603104: PPTP Tunnel created, tunnel_id is 16, remote_peer_ip is 151.27.139.69, ppp_virtual_interface_id is 1, client_dynamic_ip is 192.168.1.10"

But then he cannot access anything , in the pix's log I can see several messages like

%PIX-3-106010: Deny inbound tcp src outside:192.168.1.10/1057 dst inside:192.168.1.1/25

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.