Cisco 12406 router does not show interface 10g

[Ramon flores]

Hello,

In the Cisco 12406 router, there is a SIP-601 card, 10 giga ports SPA card and a single card 10Giga

#sho diags summary
SLOT 0 (RP / LC 0): Modular SPA Interface Card (10G)
SUBSLOT 0/0 (SPA-10X1GE-V2): 10-port Gigabit Ethernet Shared Port Adapter
SUBSLOT 0/1 (SPA-1X10GE-L-V2): 1-port 10 Gigabit Ethernet Shared Port Adapter XFP based

 SPA Information:
        subslot 0/0: SPA-10X1GE-V2 (0x508), status is ok
        subslot 0/1: SPA-1X10GE-L-V2 (0x50C), status is ok

When you run the "sho int des" command 10G interface is not displayed,

#sho version

System image file is "disk0: c12kprp-K4P-mz.120-32.SY10.bin"

2 Route Processor Cards
2 Clock Scheduler Cards
3 Switch Fabric Cards
12 Gigabit Ethernet / IEEE 802.3 interface (s)
1 10GigabitEthernet / IEEE 802.3 interface (s) ---- here is

The LED "ACTIVE / LINK" is off / off (Port is not enabled by software.)

How to turn if the interface is not shown?

I would appreciate the help you can give me.

[Muhammed Jobe · Accepted solution]

Ramon,

This is actually a known cosmetic issue that has been addressed in CSCeg59711.

GSR running IOS 12.0s and 12.0SY cannot distinguish between gig and tengig interfaces. Functionality isn't affected. This issue is only observed on GSR running IOS but not on IOS XR that is the migration path for customers on GSR.

HTH

[Ramon flores]

Thank you very much, your answer was very helpful, I figured it might be a situation ios, but I never saw that was in front of my eyes.