cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
900
Views
3
Helpful
1
Replies
mentrej
Beginner

[Cisco FAQ] - Why does the DCM still show a transport stream on a Gbe input although it is not present anymore?

How do I change this?

1 ACCEPTED SOLUTION

Accepted Solutions
Jeffrey Woo
Cisco Employee

This usually means that the input transport stream still has some settings o Check the alarm status of the input TS. Here you will see the reason why the TS still exists o Check that all input TS settings are set to the “default” value : to do this double click on the Gbe input TS and check all tabs : Services, TS FEC, TS Settings, TS Loss, TS Backup and make sure “default” settings are applied everywhere o Check that nothing is groomed anymore from the TS. From V5.1 onwards it is possible to right-click an input service and do a “Find Destinations” on it, … When all settings are reset to “default” values and nothing is groomed anymore from the TS, the TS should disappear completely after a maximum of 2 minutes

View solution in original post

1 REPLY 1
Jeffrey Woo
Cisco Employee

This usually means that the input transport stream still has some settings o Check the alarm status of the input TS. Here you will see the reason why the TS still exists o Check that all input TS settings are set to the “default” value : to do this double click on the Gbe input TS and check all tabs : Services, TS FEC, TS Settings, TS Loss, TS Backup and make sure “default” settings are applied everywhere o Check that nothing is groomed anymore from the TS. From V5.1 onwards it is possible to right-click an input service and do a “Find Destinations” on it, … When all settings are reset to “default” values and nothing is groomed anymore from the TS, the TS should disappear completely after a maximum of 2 minutes

View solution in original post