Configure Cisco Smart License in vRR node using Cisco IOS XRV9000 with VMWare

[sienny2011]

I have a problem to configure Cisco Smart License related with installing Route License up to 4m routes in vRR node using Cisco IOS XRv 9000 with VMWare.

Is there anyone could share your experience with the same case? And I saw in the documentation in Cisco Live that there is possibilities to register the Smart License manually, please advice if you have any advice in this case.

Best regards,

Sienny 

[Amit Singh]

Hello Sienny,

I am doing the similar stuff but little bit behind you. I have XRv vRR profile installed with VMware and I can login to the console using serial port. I have another physical XR router in same network. 

Can you tell me how did you assigned IP address to the vRR interface so that it can talk to other RR clients and form BGP session. 

Or if you can elaborate the process you followed it will really help me getting my setup running.

Thanks,

Amit

[khalil_shahed]

Hi

I have same problem, did you configure T1 license, my device sync only 1million license with smart license,

Thanks,

Khalil