SCE 8000 recover mode

[Geovanny Xavier Ramirez Espinoza]

Hi. I have a SCE 8000 and each time I connect the optical bypass control cable to SCE to get traffic cross it. 2-5 min later the SCE go to recover mode.

I open a TAC request and send me a new SCM but the issue ocurred again.

[Geovanny Xavier Ramirez Espinoza]

the issue was resolve. the problem is bug CSCuc76451.

apply the following workaround for this software defect:

Disable the HBC by executing the following CLI:

• SCE8000#>configure
  
• SCE8000(config)#>interface LineCard 0
  
• SCE8000(config if)#>tunable GT_PL_MODULE__HBC_ENABLED value false
  

Please make sure that this CLI is executed after applying PQB.