Hi everyone, I am working at service provider company that runs Metro Ethernet network with lots of catalyst switches. In one branch I see total output drops and this branch is for IPTV which send multicast traffic and therefore output drops immediately affect the quality of stream.
The design is so:
DATA Center <--TE Uplink--> Switch A <--1G Uplink--> Switch B
I see output drops on Switch A`s interface looking at Switch B. Although average rate on the interface is 500Mbps and this is half of real bandwidth of port, I understood that it is because of burst and the reason is packets coming from higher interface to lower one.
So is there any QOS configuration that I can implement on Switch A`s TE interface and limit burst packets?
PS: Switch A is cisco ME-3600X-24TS-M
Thanks in advance
