Reverse Terminal inside Reverse Terminal

[Nicholas Sheridan]

Scenario:

I telnet into R0

I terminal into R1 via reverse terminal 

I terminal into S1, a switch module inside R1

Question:

Whats the escape sequence to get back into R1 from S1, as doing a CRTL+SHIFT+6+X gets me back into R0?  If i then clear the line and reconnect I am back into S1?  I want to make 1 step back, not back to the root if you like.

[ghostinthenet]

The easiest thing to do is to change the escape sequence for one of the connections.

terminal escape-character 23

This will set the escape sequence to ^w rather than the usual Ctrl+^ combination, so only one router will respond to each sequence.

Greg Ferro has a good article on this here: http://etherealmind.com/changing-break-sequence-cisco-ios-useful-different/

[dancerdragon]

Thanks for this, bookmarked in my permanent list!!

Seannon