slow reply times from client (Handheld Dolphin 9550)
Hello all good people,
last time I have a problem with Dolphin scanners with long reply times.
I have four scanners directly under AP (AIR-LAP1242-E-K9, two dipole antennas). One has reply around 60ms, second the same, third around 500ms and the last one about 2500ms. All the scanners are running the same configuration with powersave mode disabled. Security is set to WPA-PSK with 63 chars long key.
We have one central controller, where are all the APs connected. Other locations do not have this problem.
I walked around with Ekahau, Spectrum and Airmagnet and found no interference or other interrupting devices.
Have somebody any ideas what can be cause of this problem?
Controller is running firmware 184.108.40.206
Ping replies, Signal strenght and SNR is attached.
It would appear to me that this issue is more than likely Terminal based and not Cisco based..? I would recommend you test the drivers on the 9550 and ensure they are all up to the lastest, one other thing is to try different AP Threshold settings on the Terminals and check to ensure it is Authenticating OK via the supplicant and not dropping in and out of Authtentication?
We want to broadcast a SSID (and allow users to connect) between certain times each day, and then take it offline. Unfortunately we dont have prime and only DNA Essential Smart licencing. All documents that I am seeing is that its possible if you have pri...
Hi all,I am looking for some guidance here, and I am quite certain that some of you, great minds, will be able to stir me in the right direction here. And a big thanks in advance. Here we go, i have three sites connected over private link MPLS....
Hi to all I purchase new AP C9120AXE converted to EWC.I notice when AP is booting a message related to default route not set that it says that can affect performance.Message is : %Default route without gateway, if not a point-to-point interface,...
Hi all, I am trying to convert AIR-AP2802I-B-K9 from CAPWAP to ME using this guide https://www.cisco.com/c/en/us/td/docs/wireless/access_point/mob_exp/1/user_guide/b_ME_User_Guide/getg_start.html#task_7588F4C009744AEFBB9EB754A713E390 I...
Hi All, Currently i have a 9800-cl wlc with 2700, 3800 and 9100 series access points (internal APs). All three APs broadcast same SSID with (WPA2/PSK) for come legacy clients which operates on 802.11b. Also I'm using the same RF, site and p...