Trying to load balance 2 DMVPN tunnels from one remote router back to our headquarters site. The remote router is a 2811 running 12.4.24. It has two DSL connections and I have built two DMVPN tunnels back to my headquarters site with each tunnel going to a seperate router. I am running EIGRP across the WAN and LAN. Please see attached drawing.
When I set two equal default routes and simply let EIGRP do the balancing the router favors the 180.7.250.1 route and very little traffic goes across the 180.7.249.1 route.
The reason I am trying this is because this site is in kind of a remote area and I can only get a 500KB up and 1.5MB down DSL circuit. So to boost performance a little I wanted to try running two circuits.
I am open to any suggestions or hints on how to get a little more bandwidth to this site.
Thanks in advance.
