03-26-2010 10:27 AM - edited 03-06-2019 10:20 AM
Hi,
I have One Switch 3548 with few vlans configured. Now I bought one more switch and want to do the following :
Switch 3548 has One VLan as 880 with network as 10.8.8.0 for ports 1 to 8. Now I added one more switch in the network, configured VLan 880 on this new switch with network same as 10.8.8.0 for ports 1 to 17.
Now I want to connect port 8 of old switch to port 17 of new switch so that 10.8.8.0 will have flow of same 10.8.8.0 network to new switch's VLan.
I tried to have both ports 8 and 17 in switchport access Vlan, but it did not work. I tried to change new switch to general, trunk but still it didn't work (but at that time I was not changing any configuration at old switch as it is in production).
Old Switch has following config :
interface FastEthernet0/8
duplex full
speed 100
switchport access vlan 880
New switch has following config :
interface FastEthernet0/17
duplex full
speed 100
switchport access vlan 880
Above did not work.
Please advise.
Thanks,
Shashi.