I am currently running WCS 7.0.164 and 1130 series access point firmware 7.0.98.0.
I am getting lot of complains from students that their laptops are not getting 5 bars signals. They are getting at least 1 or 2 bars with being disconnect frequency.
Problem is that the nearest 2 access points are showing TX power level 2. For the testing purpose, I increase tx power level to 8 on both access points and the laptop show 5 bars signals.
The layout of dorm is 3 (2 bedrooms / 2 persons per bedroom plus bathroom and living room) suites per wings.The walls are concrete.
I was told that using custom setting for TX level power is not recommend.
What are the solution to this problem? Use custom setting or what?
